just put in new shurflo pump and florenz taps small dribble of water coming out of the barbed connectors is there any special connection for them thanks
Check for an airlock in the pump. Look in the filter, ( clear plastic thingy) at one end. If it has bubbles or not full of water, then crack the filter casing open... not literally a quarter turn anti clockwise should do it, to release the air, and try again.
303mccann
Craic'er
Gender: Location: cork Age: 64 Posts: 73 Registered: 09 / 2016 My Motorhome: Base Vehicle:
The barbed bit you refer to,is than the splined piece that the tap bit that you turn goes onto?
If so there should be a nut on that to allow it to be screwed out and inside that is a seal.
Selected quotes for multi-quoting:0
Registered users in this topic
Currently no registered users in this section
The statistic shows who was online during the last 5 minutes. Updated every 90 seconds.
Note due to EU Cookie Law This page uses cookies to handle logins and unread markers. If you use this forum you allow that this page is storing cookies on your computer. To remove Cookies from this site just click on "Delete cookies of this forum" on the bottom of the page. You can find more infos in our Cookie Policy.