tap and pump

 
 
 
 
 
 
303mccann
Craic'er
Avatar
Gender:
Location: cork
Age: 64
Posts: 73
Registered: 09 / 2016
My Motorhome:
Base Vehicle:
Subject:

tap and pump

 ·  Posted: 10.06.2020  ·  #1
just put in new shurflo pump and florenz taps small dribble of water coming out of the barbed connectors is there any special connection for them thanks
Daffysparks
 
Avatar
 
Subject:

Re: tap and pump

 ·  Posted: 10.06.2020  ·  #2
Check for an airlock in the pump. Look in the filter, ( clear plastic thingy) at one end. If it has bubbles or not full of water, then crack the filter casing open... not literally😬 a quarter turn anti clockwise should do it, to release the air, and try again.
303mccann
Craic'er
Avatar
Gender:
Location: cork
Age: 64
Posts: 73
Registered: 09 / 2016
My Motorhome:
Base Vehicle:
Subject:

Re: tap and pump

 ·  Posted: 12.06.2020  ·  #3
The pump is grand it's the barbed connection's at the end of the taps that's dribbling
sprinter
Eat's Sleep's craic
Avatar
Gender:
Location: Co Wicklow
Age: 92
Posts: 7421
Registered: 01 / 2015
My Motorhome: Matilda 2 Pilote 703FP Explorateur
Base Vehicle: 3ltr 318 Sprinter Automatic
Subject:

tap and pump

 ·  Posted: 12.06.2020  ·  #4
Quote by 303mccann

The pump is grand it's the barbed connection's at the end of the taps that's dribbling


have you put a hose clip on it?
303mccann
Craic'er
Avatar
Gender:
Location: cork
Age: 64
Posts: 73
Registered: 09 / 2016
My Motorhome:
Base Vehicle:
Subject:

Re: tap and pump

 ·  Posted: 14.06.2020  ·  #5
Do you mean a gubliee clip
Liked by: sprinter
sprinter
Eat's Sleep's craic
Avatar
Gender:
Location: Co Wicklow
Age: 92
Posts: 7421
Registered: 01 / 2015
My Motorhome: Matilda 2 Pilote 703FP Explorateur
Base Vehicle: 3ltr 318 Sprinter Automatic
Subject:

tap and pump

 ·  Posted: 14.06.2020  ·  #6
Quote by 303mccann

Do you mean a gubliee clip


yes that was it.
ntg
Eat's Sleep's craic
Avatar
Gender:
Location: Portglenone. Co Antrim
Age: 24
Posts: 3822
Registered: 04 / 2012
My Motorhome: Autotrail
Base Vehicle: Comanche
Subject:

Re: tap and pump

 ·  Posted: 14.06.2020  ·  #7
The barbed bit you refer to,is than the splined piece that the tap bit that you turn goes onto?
If so there should be a nut on that to allow it to be screwed out and inside that is a seal.
Selected quotes for multi-quoting:   0

Registered users in this topic

Currently no registered users in this section

The statistic shows who was online during the last 5 minutes. Updated every 90 seconds.