Hi,
I hope someone can help with this I have an Adria Coral 660 SP 2005. The cold water tap handle of the kitchen has split (it's only plastic type stuff) I've been trying to get a new one for while now but without success. A few I've tried fit onto the tap fine but I can't close the glass lid over the sink as they are too long or to big in diameter. I've included a couple photos with sizes and the splined part seems to be for 20 teeth, but that's not a problem as I can easily buy a different 1/4 turn insert. The problem is the size of the handle. Any pointers in the right direction as to where I might get one will be greatly appreciated. The 35 mm diameter could be a little less and I think it would still fit.
I hope someone can help with this I have an Adria Coral 660 SP 2005. The cold water tap handle of the kitchen has split (it's only plastic type stuff) I've been trying to get a new one for while now but without success. A few I've tried fit onto the tap fine but I can't close the glass lid over the sink as they are too long or to big in diameter. I've included a couple photos with sizes and the splined part seems to be for 20 teeth, but that's not a problem as I can easily buy a different 1/4 turn insert. The problem is the size of the handle. Any pointers in the right direction as to where I might get one will be greatly appreciated. The 35 mm diameter could be a little less and I think it would still fit.