Hi all, as the saying goes "long time listener, first time caller"...but from all the technical posts you have here, I can't think anywhere better to ask.
Bought a 2011 Swift Escape at the beginning of 2019 and all going well. There were a few very small holes in the roof which were caused by algae which was not cleaned off and I cleaned it fully (by hand with a dish sponge) and filled all the holes.
Since doing that however, the paint has recently started blowing out on the back wall. Photos attached.
I don't know if it's because water got in and now it cannot escape anywhere but through the paint because I have effectively blocked the ventilation escape by filling the roof but it has come on very quickly in the last 2 months or so, when the weather has not been 'that' bad.
Any assistance or suggestions greatly appreciated. I have a few ideas which I'll post below.
Thank you for reading and any help or discussion you can bring.
Bryan.
Bought a 2011 Swift Escape at the beginning of 2019 and all going well. There were a few very small holes in the roof which were caused by algae which was not cleaned off and I cleaned it fully (by hand with a dish sponge) and filled all the holes.
Since doing that however, the paint has recently started blowing out on the back wall. Photos attached.
I don't know if it's because water got in and now it cannot escape anywhere but through the paint because I have effectively blocked the ventilation escape by filling the roof but it has come on very quickly in the last 2 months or so, when the weather has not been 'that' bad.
Any assistance or suggestions greatly appreciated. I have a few ideas which I'll post below.
Thank you for reading and any help or discussion you can bring.
Bryan.
You must be logged in or your permissions are to low to see this Attachment(s).